| 1–3 kg | About 1–3 kW | Small batches of aluminum, zinc, or other lower-melting-point metals | Often around 750–1,000°C, depending on the furnace design | Confirm the crucible material is compatible with the metal, flux, and operating temperature. | Jewelry work, small workshops, and testing | Check available power supply, temperature control, lid design, and whether the stated capacity refers to aluminum or another metal. |
| 5–10 kg | About 3–8 kW | Aluminum and small non-ferrous alloy batches | Often around 750–1,100°C, depending on insulation and heater design | Check the crucible’s rated temperature, usable fill level, and replacement availability. | Prototyping, repair work, and low-volume casting | Verify voltage, phase, circuit capacity, lifting or pouring method, and the manufacturer’s recommended charge size. |
| 15–30 kg | About 8–20 kW | Regular aluminum melting; some models may suit copper-alloy work if temperature-rated for it | Commonly around 800–1,200°C; confirm the maximum continuous operating temperature | Graphite or clay-graphite crucibles are commonly used for non-ferrous metals; suitability depends on alloy and furnace conditions. | Small foundries and production workshops | Compare rated capacity by metal, temperature uniformity, insulation, control accuracy, and electrical installation requirements. |
| 50–100 kg | About 25–60 kW | Higher-volume aluminum melting and compatible non-ferrous alloys | Model-dependent; copper and copper alloys require a higher temperature rating than aluminum | Check crucible dimensions, maximum charge weight, expected service life, and safe loading and pouring arrangements. | Foundry production and repeated batch melting | Assess three-phase supply, ventilation, floor loading, spill containment, operator guarding, and the supplier’s service support. |
| Above 100 kg | Typically 60 kW or more; verify against the specific design | Large batch melting of non-ferrous metals where the furnace and crucible are properly rated | Specified by the furnace design and intended alloy; do not infer suitability from capacity alone | Confirm crucible availability, handling equipment, compatibility, and procedures for inspection and replacement. | Industrial foundries with suitable power and material-handling systems | Request a documented duty cycle, rated capacity for the intended metal, energy-use data, installation requirements, and safety documentation. |