| Temperature control | Heating uniformity, sensor calibration, recipe control, and temperature monitoring at the bonding zone. | Recipe setpoint: 160 °C; logged zone readings: 159–161 °C during the example run. | Use the adhesive supplier’s qualified process window and the approved product process specification. Confirm actual temperature with a calibrated measurement method. | Recipe ID, machine ID, sensor ID, calibration status, run timestamp, and temperature log. |
| Pressure and dwell control | Repeatable pressure application, dwell-time control, platen parallelism, and alarms for out-of-range conditions. | Example recipe: 0.30 MPa for 45 s. | Values must be validated for the specific stiffener, adhesive, FPC stack-up, and tooling. Do not treat the example recipe as a general requirement. | Pressure and dwell setpoints, measured or monitored values, operator, and recipe revision. |
| Stiffener positioning | Registration method, fixture repeatability, vision or alignment aids, and support for the panel format. | Example inspection result: maximum measured offset 0.12 mm across 10 sampled parts. | Compare with the approved drawing’s location and dimensional tolerances. Record the measurement method and sample size. | Panel or lot ID, drawing revision, sample locations, measurement results, and inspection equipment ID. |
| Bond coverage and voids | Control of adhesive placement, surface cleanliness, pressure distribution, and inspection access. | Example inspection: no visible edge lift; 2 small void indications noted in 10 inspected bonds. | Apply the customer-approved acceptance criteria and inspection method. IPC-6013 requirements should be checked against the contractually applicable revision and class. | Inspection method, images or inspection report, inspector, lot ID, and disposition of any nonconformance. |
| Bond strength verification | Ability to produce repeatable bonds and support process qualification and periodic verification. | Example peel-test results: 0.82, 0.86, and 0.84 N/mm on three qualification coupons. | Set the test method, specimen preparation, conditioning, and minimum acceptance value in the approved specification. These sample results are not an IPC-6013 limit. | Test method and revision, coupon construction, test equipment calibration, individual results, and approval record. |
| Material and process compatibility | Support for the actual adhesive type, stiffener material and thickness, FPC construction, and required cure or bonding cycle. | Example material record: 0.20 mm stiffener; adhesive lot and shelf-life status verified before use. | Confirm compatibility using material data sheets, approved stack-up documentation, and a documented qualification run. | Material names and lot numbers, expiration status, stack-up revision, and process qualification reference. |
| Recipe control and change management | Role-based access, recipe revision history, controlled parameter changes, and prevention of unauthorized edits. | Example audit entry: recipe revision B; change approved before production release. | Ensure settings used for production match the released process documentation and applicable quality-system controls. | Recipe revision, change history, approver, effective date, and linked engineering change record. |
| Production traceability | Ability to associate each run with the product, lot, materials, machine, operator, and process record. | Example run record: work order, panel ID, adhesive lot, operator ID, and timestamp captured. | Verify required records against the purchase order, customer requirements, and internal quality plan. | Searchable, retrievable run record with retention period defined by the applicable quality and contract requirements. |
| Equipment qualification and maintenance | Installation and operational checks, preventive maintenance, calibration status, and documented requalification after relevant changes. | Example status: calibration current; preventive maintenance completed within the scheduled interval. | Use the organization’s approved equipment-control procedure and documented process qualification criteria. | Qualification report, maintenance history, calibration certificates, and any corrective-action records. |