| AISI 4130 | Normalized or quenched and tempered | Moderate to high; properties vary substantially with heat treatment and section size. | Good toughness and fatigue performance when properly heat-treated; weldable with suitable procedures. | Generally good in the annealed condition; harder heat-treated conditions require more effort. | Low; requires a protective coating or other corrosion-control measures in wet or outdoor service. | Aircraft tubing, structural components, pressure-related parts, and welded fabrications. |
| AISI 4140 | Annealed, normalized, or quenched and tempered | High in the quenched-and-tempered condition; strength depends on tempering temperature and section size. | Good combination of strength, wear resistance, and toughness for general engineering use. | Fair to good when annealed; more difficult to machine as hardness and strength increase. | Low; chromium in this grade does not make it stainless steel. | Shafts, gears, bolts, tooling, and other highly stressed machine components. |
| AISI 4340 | Usually quenched and tempered for high-strength applications | Very high potential strength; heat treatment and component size must be specified for reliable values. | High strength with good toughness when correctly heat-treated; suitable for demanding cyclic loads. | Fair in the annealed condition; challenging to machine at higher hardness levels. | Low; surface protection is normally needed where moisture or chemicals are present. | Heavy-duty shafts, landing-gear components, gears, and high-stress fasteners. |
| AISI 8620 | Carburized and case-hardened, with a relatively tough core | High surface hardness after carburizing; core strength is lower and depends on the treatment and section. | Excellent wear resistance at the case with a tough core that helps resist impact loading. | Good before case hardening; finishing after hardening may require grinding or specialized processes. | Low; the hardened case does not provide stainless-level corrosion protection. | Gears, pinions, cams, and components needing a hard wear surface and a tougher core. |
| AISI 52100 | Hardened bearing steel, commonly used at high hardness | Very high hardness and compressive strength after hardening; tensile properties depend on processing and test method. | Excellent rolling-contact fatigue and wear resistance; less suitable for severe impact than tougher, lower-hardness grades. | Good in the annealed condition; difficult to machine after hardening. | Low; careful storage, lubrication, or a protective coating may be needed to prevent rust. | Rolling-element bearings, races, rollers, and wear-resistant parts. |