| 1. Identify the cylinder type and sealing location | Record whether each seal is for a piston, rod, gland, or static joint. Note the cylinder bore and rod diameter. | Compare the kit application data with the equipment drawing or measured cylinder dimensions. Similar-looking kits may contain seals for different locations. |
| 2. Confirm the O-ring size notation | Check the O-ring inside diameter (ID) and cross-section (CS), and confirm whether dimensions are stated in millimetres or inches. Common nominal cross-sections used in seal sizing include approximately 1.78, 2.62, 3.53, and 5.33 mm; these examples do not identify a complete seal size. | Match both ID and CS to the drawing or specified standard. Do not select an O-ring by cross-section alone, and do not assume a conversion or rounded value is an exact nominal size. |
| 3. Check tolerances against ISO 3601 | Review the applicable ISO 3601 part, size, tolerance class, and any stated dimensional limits for the O-ring. ISO 3601-1 covers O-ring dimensions and tolerances. | Ask for dimensional specifications or inspection results where needed. Compare the stated limits with the relevant ISO 3601 requirements; avoid applying one generic tolerance to every O-ring size. |
| 4. Verify the gland and groove dimensions | Check groove diameter, width, depth, corner radii, and available installation space against the cylinder drawing. ISO 3601-2 addresses housing dimensions for O-rings. | Use the correct housing design for the seal location and service conditions. A correctly sized O-ring can still leak or wear quickly if the groove geometry is unsuitable. |
| 5. Match seal material to the fluid and temperature | Confirm the specified elastomer and its compatibility with the working fluid, operating temperature, and exposure conditions. | Use a compatibility reference or obtain material data for the exact fluid and temperature range. Do not assume seals made from different elastomers are interchangeable. |
| 6. Check backup rings and installation details | Verify backup-ring quantity, material, orientation, and fit where the design calls for them. Check that included seals correspond to the correct grooves. | Follow the equipment assembly drawing and installation instructions. Inspect seal edges and grooves for damage, and use a lubricant compatible with both the seal material and system fluid. |
| 7. Validate the kit before installation | Compare the parts list and measured samples with the required IDs, cross-sections, groove dimensions, materials, and applicable tolerance specifications. | Measure with suitable, calibrated equipment and avoid stretching or compressing an O-ring during measurement. Record discrepancies before assembly and confirm the relevant ISO 3601 edition with the specification. |