| Wire splices | Over joined conductors in control panels, appliances, vehicles, and electrical equipment | Insulates the joint and helps protect it from abrasion, handling, and contact with nearby conductors. | Choose a sleeve that fits over the splice before shrinking and recovers closely around the insulated wires. Use a properly rated splice connector and follow applicable electrical requirements. |
| Cable harness branches | At branch points where one or more wires split from a main harness | Bundles and covers the branch area, helping reduce snagging and wear while keeping the harness organized. | Check the sleeve’s expanded diameter, recovered diameter, and length against the harness bundle and branch geometry. |
| Wire-to-cable transitions | Where individual wires meet a multicore cable or another cable section | Covers the transition and provides insulation and mechanical protection. | For irregular shapes, verify that the sleeve can recover evenly over the full transition without leaving gaps or excessive stress. |
| Connector backs and cable exits | Behind connectors, plugs, and equipment entry points | Provides a protective covering and can help support the cable exit when the sleeve is suitable for that purpose. | A heat-shrink sleeve is not automatically a substitute for a rated strain-relief fitting. Confirm the required bend, pull, and environmental protection. |
| Cable terminations | At cable ends and termination points, including insulated connection areas | Insulates and covers exposed or vulnerable areas when used with an appropriate termination design. | Match the sleeve material and dimensions to the cable, operating temperature, voltage, and installation conditions. |
| Moisture-exposed joints | Outdoor or damp locations where a splice or transition needs additional sealing | Adhesive-lined sleeves can melt and flow during shrinking to help seal around the covered components. | Use an adhesive-lined product specifically suited to the exposure. Heat shrink alone does not guarantee a waterproof or submersible seal. |
| Identification and grouping | Harness sections, wire groups, and selected termination areas | Can provide a neat covering and, for products designed for marking, support circuit or cable identification. | Confirm that the sleeve is intended for printing or identification if labels or markings are required. |