| Tube dimensions | Outside diameter, wall thickness, cross-section, and maximum tube length. | Confirm capacity using the actual tube dimensions and the bend radius required; published maximum capacity may depend on material and tooling. | A machine that handles the diameter may not handle the same tube at a thinner wall or tighter radius. |
| Aluminum alloy and temper | Alloy, temper, tube condition, and material certification where applicable. | Run trials with the production material. Different alloys and tempers can vary in formability and springback. | Material behavior affects cracking risk, dimensional accuracy, and the settings needed for repeatable bends. |
| Bend radius and quality | Minimum centerline radius, ovality limits, surface finish, and allowable wall thinning. | Specify the required radius-to-diameter ratio and acceptable part tolerances when requesting a machine trial. | Tighter bends generally demand better workpiece support and more carefully matched tooling. |
| Bending process | Rotary-draw, roll, or another process suited to the part geometry. | Rotary-draw bending is commonly used for controlled, repeatable bends; roll bending is often considered for large-radius curves. | The process affects achievable geometry, part quality, tooling needs, and production workflow. |
| Workpiece support and tooling | Bend die, clamp die, pressure die, wiper die, and mandrel options. | For thin-wall tubes or tight bends, ask whether mandrel and wiper-die support is available and properly matched to the tube. | Appropriate support can help control wrinkling, flattening, and other deformation; results still depend on material and setup. |
| Control and repeatability | Manual, programmable, or CNC control; stored programs; bend-angle and feed settings. | Choose controls based on part complexity and changeover frequency, and verify repeatability with a production-representative test. | Programmable controls can reduce setup variation on multi-bend parts and repeated production runs. |
| Production volume and cycle time | Parts per shift, number of bends per part, loading method, and changeover time. | Estimate output using the complete workflow, including loading, clamping, bending, unloading, and inspection. | A quoted bending speed alone does not represent total production cycle time. |
| Setup and changeover | Tool-change method, adjustment access, program storage, and setup documentation. | For mixed production, compare the time and skill required to switch between tube sizes and part programs. | Faster, more predictable changeovers can improve usable machine time in short-run work. |
| Space and utilities | Machine footprint, tube infeed and outfeed clearance, electrical supply, and any air or hydraulic requirements. | Check the machine layout and utility specifications against the available floor space and site supply before installation. | Long tubes may need substantial clearance beyond the machine’s stated footprint. |
| Safety and operator access | Guards, emergency stops, interlocks, safe loading, and access to adjustment points. | Review the machine’s safety features and operating instructions as part of the site risk assessment. | Safe access and suitable safeguards are essential for routine operation and maintenance. |
| Total cost of ownership | Machine, tooling, installation, training, maintenance, energy use, and spare parts. | Compare the expected cost over the planned service life, not only the initial purchase price. | Tooling and support costs can materially affect the economics of a bending operation. |
| Service and training | Operator training, maintenance guidance, spare-part availability, and technical support arrangements. | Confirm what commissioning and training are included and how routine service needs will be handled. | Good support helps operators maintain consistent setups and reduces avoidable downtime. |