| Servo motor system |
Closed-loop control commonly uses an encoder or resolver to measure position and speed; the controller corrects motion based on feedback. |
Well suited to coordinated motion, controlled acceleration, and repeatable positioning. Achievable accuracy depends on the motor, feedback device, mechanics, tuning, and load. |
Responsive motion; good control across a range of speeds; can detect and correct certain position errors. |
Usually requires more setup and tuning than a basic open-loop system. Sizing, feedback, and controller selection affect cost and performance. |
Packaging machinery, robotics, CNC axes, pick-and-place equipment, and automated assembly. |
| Stepper motor system |
Often operated open-loop by sending step commands; encoder-equipped closed-loop versions are also available. |
Moves in commanded increments and can provide useful positioning at low-to-moderate speeds. In open-loop operation, missed steps may go undetected. |
Simple motion control and strong holding torque at standstill relative to motor size; can be practical for repetitive point-to-point motion. |
Available torque generally falls as speed rises. Resonance, heating, and loss of synchronism under excessive load can limit performance. |
Small automation axes, labelers, feeders, laboratory equipment, and light-duty positioning stages. |
| Brushless DC (BLDC) system |
Electronic commutation replaces mechanical brushes. Rotor-position information may come from sensors or sensorless estimation; feedback options vary by system. |
Supports efficient continuous rotation and speed control. Precise positioning typically requires suitable position feedback and a motion controller. |
No brushes to replace; good efficiency and power density in many designs; suitable for frequent speed changes. |
Requires electronic drive electronics. Low-speed smoothness and positioning capability depend on motor design, feedback, and control method. |
Small pumps, fans, conveyors, compact automation, and equipment needing efficient variable-speed rotation. |
| AC induction motor with a variable-frequency drive (VFD) |
A VFD adjusts motor frequency and voltage to control speed. Basic systems may be open-loop; encoder feedback or advanced control can improve regulation. |
Well suited to variable-speed rotation. Accurate axis positioning generally requires additional feedback and motion-control capability. |
Robust, widely used motor technology; practical for continuous-duty loads and applications where speed control matters more than precise positioning. |
Positioning response and low-speed performance depend on the motor, VFD control mode, and feedback. Not usually the simplest choice for fast, precise axes. |
Pumps, fans, mixers, process equipment, and general-purpose conveyors. |
| Direct-drive torque motor |
Typically paired with an encoder and closed-loop controller; the motor drives the load directly without a gearbox. |
Provides high torque at low rotational speed and supports precise rotary motion when correctly integrated with feedback and mechanics. |
Eliminates gearbox backlash and wear; can reduce mechanical parts and support smooth, direct rotary movement. |
May require a larger motor and careful management of heat, cabling, bearing loads, and system integration. |
Rotary indexing tables, turntables, telescope mounts, machine-tool rotary axes, and precision inspection equipment. |
| Linear motor system |
Uses a linear motor with position feedback, such as a linear encoder, for closed-loop control of straight-line motion. |
Produces linear thrust directly, without converting rotary motion through a screw or belt. System accuracy depends on feedback, guideways, alignment, and thermal effects. |
Can support high acceleration and smooth travel while avoiding screw or belt transmission backlash. |
Requires suitable guides and feedback; installation, thermal management, and protection from dust or debris may need special attention. |
High-speed inspection stages, semiconductor equipment, precision positioning, and selected material-handling systems. |